Abstract | 第4页 |
Chapter 1 Introduction | 第7-11页 |
1.1 Background | 第7页 |
1.2 Justification of the choice of the Research | 第7-8页 |
1.3 Objectives | 第8-9页 |
1.4 Outline of the Report | 第9-11页 |
Chapter 2 Capacitor Bank Application | 第11-25页 |
2.1 General | 第11-13页 |
2.2 Connections | 第13-14页 |
2.2.1 Series Capacitors | 第13页 |
2.2.2 Shunt Capacitors | 第13页 |
2.2.3 Types of Three Phase Capacitor Bank Connections | 第13-14页 |
2.3 Power Factor | 第14-20页 |
2.3.1 Power Factor Correction | 第16-18页 |
2.3.2 Voltage improvement | 第18-19页 |
2.3.3 Economic benefits from capacitor installations | 第19-20页 |
2.4 Techniques for choice of fixed and switched capacitors | 第20-25页 |
2.4.1 The rule of thumb Method | 第21-22页 |
2.4.2 Nomogram Method | 第22-23页 |
2.4.3 The computerized method | 第23-25页 |
Chapter 3 Choice of controls for switched Shunt capacitors | 第25-36页 |
3.1 Distribution Capacitor: Switch-On | 第25-26页 |
3.2 Isolated Bank Switching | 第26页 |
3.3 Back to Back Switching | 第26-27页 |
3.4 Control Options | 第27-29页 |
3.4.1 General | 第27-28页 |
3.4.2 Current Limiting and Harmonic Inductors | 第28-29页 |
3.5 Transient over-voltage caused by capacitor bank switch off | 第29-31页 |
3.6 Protection | 第31-36页 |
3.6.1 Fuse Type Protection | 第31-32页 |
3.6.2 Relay Type Protection | 第32-34页 |
3.6.3 Protection by Surge Arresters (MOA) | 第34-36页 |
Chapter 4 Application of Capacitors to Distribution Substation | 第36-54页 |
4.1 A Typical Nigerian Rural Electric transmission System | 第36-37页 |
4.2 Biu-Shani System Performance of Analysis | 第37-39页 |
4.2.1 Load Flow Studies | 第37-39页 |
4.3 The Design of the Biu-Shani Reactive Power Compensation System | 第39-42页 |
4.3.1 Capacitor bank selection | 第39-41页 |
4.3.2 Avoidance of fixed connection banks | 第41-42页 |
4.3.3 Avoidance of harmonics | 第42页 |
4.3.4 Avoidance of over voltage and switching surges | 第42页 |
4.3.5 Avoidance of re-strike | 第42页 |
4.4 Calculation of Modeled components in PSCAD | 第42-43页 |
4.4.1 Calculation of the capacitor banks | 第42-43页 |
4.4.2 Series reactor rating | 第43页 |
4.5 Economic benefits | 第43-44页 |
4.5.1 Benefit due to release capacity | 第43页 |
4.5.2 Benefits due to Voltage profile Improvement | 第43-44页 |
4.6 Models simulation | 第44-54页 |
4.6.1 Case Ⅰ:no transient limiting employed | 第45-47页 |
4.6.2 Case Ⅱ:full-time inductor employed | 第47-54页 |
Chapter 5 Conclusion and recommendation | 第54-55页 |
References | 第55-59页 |
攻读硕士学位期间发表学术论文情况 | 第59-60页 |
致谢 | 第60-61页 |